|
|
Item Posts
Sort Order
|
|
|
|
motor fit
|
doceby
New User
| Posts: 2
| Joined: 01/11
Posted: 01/04/11
05:37 AM
|
|
I have a 1929 gazelle and it has a 1975 1600 eng. I would like to upgrade. I found rebuilt 1978 bus 2000cc recondition block will it fit on my clucth/transaxle.Also I missed the descussion on converting to a hydrailc clucth, is it possible. I need parts any places come to mind.
doceby
|
|
|
|
3836bbl
New User
| Posts: 28
| Joined: 01/11
Posted: 01/24/11
03:44 PM
|
|
doceby 1st off welcome to the forum. 2nd I need to say I'm not an expert on VW's but have had a few & doe multiple mods with them. The trans should be the same bolt pattern,I think it's been a long time sence I messed with VW's, your converting to a hyd. clutch is as simple as adding a single hyd. master cylinder, plumb that to a slave cylinder & peddle assembly for the clutch then mount the slave cylinder on the block or bellhousing use a rod between the slave cylinder & the accuation clutch fork from th original set-up, Or buy a hyd. throughout bearing set-up & it will act as the slave cylinder & linkage combined. I hope this helps some all be it some what late. 3836bbl/Budnicks
Buy the book "how to build a _______" or "how to tune a ______" you fill in the blanks. 3836bbl/Budnicks
|
|
|
|
|
|
|
|
|